Battery Tester With Printer, Service Test

Battery Tester with Printer, Service Test

CAUTION!
Batteries that have a colorless or light yellow visual indicator do not have to be tested or charged. Jump starting must not be used!

There is a risk of explosion during testing, charging or jump starting.

These batteries must be replaced.

- Select service test.

- Select at the battery pole or at the battery jump start terminal.

- Section vehicle model.

- Measure the temperature. Hold the temperature sensor approximately 5 cm above the battery pole until the temperature is stable.

- Select the type of battery: standard, AGM, 2*6V or Gel.

- Select the CCA, JIS, DIN, SAE, IEC or EN.

- Start the test.

- Print out the test report if necessary.