Jump Start Point With Suppressor

Jump Start Point with Suppressor

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

- Disconnect battery, refer to => [ Battery In Luggage Compartment, Disconnecting and Connecting ] Battery In Luggage Compartment, Disconnecting and Connecting.

• Air filter housing is removed for reasons of clarity. It is not required when doing repairs.

- Disengage retaining clip - arrow A - and open cover - 1 - over positive pole pick-up.





- Disengage cover - 2 - over electrical wires in - direction of arrow B -.

- Remove the nuts - 5 - and - 6 - on positive wires.





- Disconnect electrical harness connector - 1 - at suppressor - 4 -.

- Remove screw - 3 - and remove positive terminal trip - 2 - with suppression filter from bracket.

Installing:

Install in reverse order.

- Tighten all threaded connections to specified torque shown in => [ Fastener Tighten Specifications, External Starting Point ] [1][2]Jump Starting.

- Reconnect battery, refer to => [ Battery In Luggage Compartment, Disconnecting and Connecting ] Battery In Luggage Compartment, Disconnecting and Connecting.