EVAP System Components

EVAP System Components

=> [ EVAP Canister ]

GTI => [ ]

Eos => [ ]

EVAP Canister

Special tools, testers and auxiliary items required

• Engine/Transmission Jack (V.A.G 1383 A)

Removing

- Remove the center and rear mufflers.

- Remove the shield bolts - arrows - and shield.





- For supporting purposes, place the (V.A.G 1383 A) under the rear subframe.

- Loosen the rear subframe bolts - arrows - and unscrew them approximately 20 mm.





- Slowly lower the rear subframe using (V.A.G 1383 A).

- Disconnect the vent lines - A - by pressing the release buttons.





- Remove the bolts - B -.

• A reinforcement plate is installed on the Eos. Use (3185) to loosen and tighten the bolts - B -.

- Release the retaining straps - A - using a screwdriver. Rotate the Evaporative Emission (EVAP) canister approximately 90 degrees clockwise - B - and remove the EVAP canister.





Installing

Installation is performed in the reverse order of removal, noting the following:

- Connect the ventilation lines until they engage audibly.

- Install the rear subframe.

Tightening Specifications






Leak Detection Pump (V144)

Removing

- Remove the right rear wheel housing liner..

- Disconnect the vacuum line - 1 -.





- Separate the electrical connector - 2 -.

- Disconnect the vent line - 3 - by pressing the release button.

- Remove the nuts - arrows -.

- Disengage the leak diagnostic pump with bracket.

Installing

Installation is performed in the reverse order of removal, noting the following:

• Vent line - 3 - must engage audibly.

- Install the right rear wheel housing liner..

Tightening specifications, refer to => [ EVAP System Component Overview ] EVAP System Component Overview.

Leak Detection Pump (V144)

Removing

- Remove the vacuum line - 1 -, ventilation line - 2 - and ventilation line - 3 -.





- Remove the nuts - arrows -.

- Remove the leak detection pump with bracket and disconnect the electrical connector.

Installing

Installation is performed in the reverse order of removal, noting the following:

• Before installing the leak detection pump with bracket, connect the electrical connector.

• Vent line - 2 - must engage audibly.

Tightening specifications, refer to => [ EVAP System Component Overview ] EVAP System Component Overview.