RC. Adjustment of Throttle Switch

RC. Adjustment of throttle switch

RC1




Assembly, disassembly of throttle switch
- Disconnect the throttle switch.
- Unscrew and remove the throttle switch. Replace screws with new ones with red threads (PIN 977 762-4). Alternatively, use looking fluid on existing screws.
- Do not tighten the screws; let the throttle switch sit loosely.
- Rotate the throttle clockwise.
^ Continue with Adjustment of throttle switch RC2.

RC2




Adjustment of
- Place a 0.25 mm feeler gauge between the lever and the adjustment screw.
- Rotate the throttle switch slowly until it "clicks".
- Screw tight the throttle switch in this position (1.2-2.0 Nm).
^ Continue with Follow-up check RC3.


RC3




Follow-up check
- Open the throttle and check the gap between the lever and adjustment screw with a feeler gauge.
With a 0.45 mm feeler gauge there should be no clicking sound when the throttle closes.
With a 0.15 mm feeler gauge there should be a clicking sound when the throttle closes.
- Connect the connector to the throttle switch.
^ Continue with RD. Adjustment of throttle control RD. Adjustment of Throttle Control