C9 Checking Ignition Supply (15)
C9 Checking ignition supply (15) to central locking relaySwitch ignition off.
Connect a voltmeter between position 15 on relay base D and position 31 on relay base N.
Voltmeter should read approx. 0 Volt.
Switch ignition on.
Connect a voltmeter between position 15 on relay base D and position 31 on relay base N.
Voltmeter should read battery voltage.
If both readings are correct: Go to C10. C10 Checking M- Lead to Central Locking Motors
If either reading is incorrect:
Open-circuit or short-circuit to ground in supply lead between relay base position 15 and passenger compartment fusebox position 11C/11:2 to fuse 11.
Correct fault or replace ignition supply lead to central locking relay.
Replace central locking relay D/G and driver's door relay N.