Manually Programming Entry Position

Manually programming entry position

Programming entry position

Location Of Components:

- Adjust the front-rear position of the seat to the most forward position using the control button.
- Move the seat backward approximately 5 mm.
- Press the MEM button (4) and hold down (otherwise the seat moves forward with the following command).
- Fold the backrest forward using the handle (5). Hold the handle up.
- Press the MEM buttons 1, 2 and 3 at the same time (1, 2 and 3).

Note! Do not release the fold handle and other buttons.

Wait at least 5 seconds.

Conclusion
The preset entry position is now programmed into the control module.