Sunroof / Moonroof Module: Service and Repair

Control module, sun roof, replacing

The illustrations in this service information are used for different model years and / or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparations




Close the sun roof.
Ignition off.




Remove the key.

Note! After removing the key, wait one minute before starting work.

Removing the sun roof control module





Remove:
- the upper electronic module (UEM). See Interior lighting and upper electronic module (UEM), replacing Service and Repair
- the first connector
- 1 screw.
Detach the control module and lift it down.

Remove:
- the second connector
- the control module for the sun roof.

Installing the sun roof control module

Note! For tightening torques, see relevant specfications.

Install:
- the small connector
- the control module
- 1 M6 screw. Tighten
- the large connector
- the upper electronic module (UEM). See Interior lighting and upper electronic module (UEM), replacing Service and Repair.
Calibrate the control module for the sun roof. See Sun roof module (SRM), calibrating Programming and Relearning.