Transaxle, Removing

Transmission

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Note! Removal steps in this procedure may contain installation details.

Remove the brackets for auxiliary equipment.
Drain the cooling system. Refer to: Cooling system - draining, charging and bleeding Service and Repair.

Torque: M6, 10 Nm

Torque: M8, 24 Nm

Remove the following items:
1. Torque: M10, 50 Nm

2. Torque: M8, 24 Nm

Remove the following items:
- Front subframe. Refer to: Sub-frame front, replacing, B6324S5 Service and Repair
- left driveshaft.
- Refer to: Bevel gear, TF-80SC AWD Bevel Gear, Replacing.

Torque: M10, 50 Nm

Caution! Make sure that all openings are sealed.

Remove the following items:
1. Torque: M8, 24 Nm

2. Torque: M10, 50 Nm

3. Torque: M6, 10 Nm

Remove the following items:
- starter motor. Refer to: Starter motor, B6324S5 Service and Repair
- front crankshaft seal. Refer to: crankshaft front seal, B6324S5 Service and Repair.

999 7257 Wrench 999 7257 Wrench.
Tightening torque:Torque converter to carrier plate. Refer to: Tightening torque Tightening Torque.

999 5972 FIXTURE 999 5972 Fixture.

Torque: M10, 50 Nm

Note! This step is only necessary when installing a new component.

Torque: M8, 24 Nm

Installation

Prepared transaxle. Refer to: Transmission, preparations before installing , TF-80SC AWD, TF-80SC Transmission, Preparations Before Installing.
To install, reverse the removal procedure.

Note! This step is only necessary when installing a new component.

Order and download appropriate software Programming and Relearning