Rear Toe

NOTE: Use commercially-available computerized four wheel alignment equipment to measure wheel alignment (caster, camber, toe and/or turning angle). Follow the equipment manufacturer's instructions.

1. Release parking brake. Rear toe-in: 2 ± 2 mm (1/16 ± 1/16 inch).

NOTE:
- Measure difference in toe measurements with the wheels pointed straight ahead.
- If the parking brake is engaged, you may get an incorrect reading.

a. If adjustment is required, go to step 2.
b. If no adjustment is required, remove alignment equipment.





2. Hold the adjusting bolt on the rear lower arm A and loosen the self-locking nut.
3. Adjust the rear toe by turning the adjusting bolt until toe is correct.
4. Install the self-locking nut, and tighten it while holding the adjusting bolt.