Removal And Installation

STARTER / REPLACEMENT


NOTE: The original radio has a coded theft protection circuit. Be sure to get the customer's code number before
- disconnecting the battery.
- removing the No. 47 (7.5 A) fuse from the under-hood fuse/relay box.
- removing the radio.

After service, reconnect power to the radio and turn it on. When the word "CODE" is displayed, enter the customer's 5-digit code to restore radio operation.

1. Disconnect the negative cable from the battery.







2. Remove the intake air duct.







3. Remove the engine wire harness and starter cables from their brackets.
4. Disconnect the starter cable from the B terminal on the solenoid, then disconnect the BLK/WHT wire from the S terminal.







5. Remove the two bolts holding the starter, then remove the starter.
6. Install in the reverse order of removal.