Ignition Key Switch Test

SRS components are located in this area. Review the SRS component locations, precautions, and procedures in SRS before performing repairs or service.

Ignition Key Switch Test:

1. Remove the dashboard lower cover, and disconnect the connectors.
2. Disconnect the 8P connector from the floor wire harness.

Ignition Key Switch Test:

3. Check continuity at the switch connector terminals.
- There should be continuity between the No. 8 and No. 7 terminals with the ignition key inserted into the ignition key cylinder.
- There should be no continuity between terminals No. 8 and No. 7 with the ignition key removed.