Power Mirror Motor: Service and Repair

Power Mirror Actuator Replacement

1. Remove the power mirror from the door, and disconnect the 6P ('99-01 models) or 13P ('02-03 models) connector.




2. Cut the wire harness with wire cutters.
3. Record the terminal locations and wire colors.
4. Remove the mirror holder.




5. Remove the three screws (A) and the actuator (B).




6. Route the wire harness (A) of the new actuator through the hole in the bracket (B).







7. Insert the terminals into the connector as shown.
8. Apply tape to seal the intersection of the wire harness.
9. Reassemble in the reverse order of disassembly. Be careful not to break the mirror when reinstalling it to the actuator.
10. Reinstall the mirror assembly to the door.
11. Operate the power mirror to ensure smooth operation.