Removal And Installation
Starter Replacement1. Make sure you have the anti-theft code for the radio and the navigation system, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least 3 minutes.
3. Unlatch the ATF cooler hose clamp (A), then disconnect the starter cable (B) and BLK/WHT wire (C).
4. Remove the two bolts holding the starter, then remove the starter.
5. Install in the reverse order of removal. Make sure the crimped side of the ring terminal is facing out.
6. Connect the battery positive cable and negative cable to the battery.
7. Start the engine to test the starter.
8. Enter the anti-theft code for the radio and the navigation system, then enter the customer's radio station presets.