Transmission Cooler: Service and Repair
ATF Cooler Replacement1. Disconnect the ATF cooler hose from the ATF cooler, and remove the ATF cooler and line.
2. Install the new ATF cooler on (A) the body.
3. Connect the ATF cooler hose (B) to the ATF cooler line, and secure the hose with a clip. Slide the hose over the connector line (C) until the hose end contacts the bulge (D), and secure the hose with a clip (E) at 6 - 8 mm (0.2 - 0.3 inch) (F) from the hose end.
4. Install the connector line on the body.,
5. Slide the hose (G) over the connector line until the hose end contacts the bulge (H), and secure the hose with a clip (I) at 6 - 8 mm (0.2 - 0.3 inch) (J) from the hose end.
6. Connect the hose (K) to the ATF cooler line, and secure the hose with a clip. Install the hose on the clamp (L) at the mark (M).