Trunk Pass-Through Cover Key Cylinder Replacement
Trunk Pass-through Cover Key Cylinder ReplacementSpecial Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the cover.
1. Using a trim tool, pry the rear seat handle (A) up at both hook portions (B) on the forward side of the trunk pass through cover (C). Then slide the handle half-way up.
2. From the trunk compartment side of the cover, using a small screwdriver, press the inside hook (A) down through the access hole (B).
3. While pressing the hook, pry the trunk-side handle (C) up with a trim tool.
4. Remove the trunk-side handle (A) and rear seat handle (B) at the same time.
5. Remove the retainer clip (C), then remove the trunk pass4hrough cover key cylinder (D) from the cover (E).
6. Install the key cylinder in the reverse order of removal, and note these items:
- Put the two handles together before installing them on the trunk pass-through cover.
- Make sure the trunk pass-through cover opens properly and locks securely.