Programming and Relearning

Moonroof Control Unit Reset

NOTE: Do the moonroof control unit reset with all the doors and tailgate closed.

Reset the moonroof after doing any of the following actions.

- The moonroof was moved manually with the battery dead or disconnected.

- If the moonroof control unit experienced a large voltage drop between fully opened, closed, or tilt positions.

- The moonroof motor was replaced with a new one.

- Any components related to the moonroof were replaced.
- Wind deflector

- Moonroof glass

- Moonroof seal

- Moonroof glass bracket

- Moonroof cables, etc.

To reset the moonroof control unit, do these steps

1. Close all the doors and the tailgate.

2. Turn the ignition switch to LOCK (0).

3. Press and hold the center of the moonroof switch (tilt), and turn the ignition switch to ON (II).

4. Release the moonroof switch and turn the ignition switch to LOCK (0).

5. Repeat steps 3 and 4 an additional four times.

6. Pull and hold the moonroof switch (open) an additional 3 seconds after the moonroof is fully opened.

7. Press and hold the moonroof switch (close) an additional 3 seconds after the moonroof is fully closed.

8. Confirm that the moonroof control unit is reset by using the moonroof AUTO OPEN and AUTO CLOSE function.