Operation CHARM: Car repair manuals for everyone.
Home >> Acura >> 2009 >> MDX V6-3.7L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Seat Occupant Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Seat Occupant Sensor: Service and Repair




Front Passenger's Weight Sensor Replacement

Removal

NOTE:

- Removal of the front passenger's weight sensors must be done according to Precautions and Procedures. Service and Repair

- The front passenger's weight sensors are part of the slide/up-down adjuster and must be replaced as an assembly.

1. Do the battery terminal disconnection procedure, Procedures then wait for 3 minutes before starting work.

2. Remove the front passenger's seat assembly. Front Seat Removal/Installation

3. Remove the front cover, recline cover, and center cover. Front Seat Disassembly/Reassembly

4. Disconnect the sensor connector's (A) from the ODS unit harness, then remove the mounting nuts (B) and mounting bolts (C) from weight sensors (D).

5. Disconnect the sensor connectors (D) from the ODS unit harness, then remove the front passenger's weight sensors.






Installation

NOTE: Be sure to install the harness wires so they are not pinched or interfere with other parts.

1. Install and torque the new front passenger's weight sensors with mounting nuts (A) and new mounting bolts (B) under the seat cushion.

2. Reinstall the front passenger's seat. Front Seat Removal/Installation

3. Do the battery terminal reconnection procedure. Procedures

4. Calibrate the ODS unit. ODS Unit Calibration

5. After installing the front passenger's weight sensors, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come ON for about 6 seconds and then go off.





pro multis · About Operation CHARM