Operation CHARM: Car repair manuals for everyone.
Home >> Acura >> 2009 >> MDX V6-3.7L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Seat Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Seat Position Sensor: Service and Repair




Driver's Seat Position Sensor Replacement

Removal

NOTE:

- Removal of the driver's seat position sensor must be done according to Precautions and Procedures. Service and Repair

- Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.

1. Do the battery terminal disconnection procedure, Procedures then wait for 3 minutes before starting work.

2. Disconnect the driver's airbag 4P connector. Service and Repair

3. Remove the driver's seat assembly. Front Seat Removal/Installation

4. Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor.

5. Using a TORX T30 bit, remove the TORX bolt (B), then remove the driver's seat position sensor.






Installation

NOTE:

- Be sure to install the harness so it does not pinched or interfere with other parts.

- Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.

- After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.

1. Install the new driver's seat position sensor with a TORX bolt (A), then connect the driver's seat wire harness 2P connector to the driver's seat position sensor (B).

2. Reconnect the driver's airbag 4P connector. Service and Repair

3. Install the driver's seat assembly. Front Seat Removal/Installation

4. Do the battery terminal reconnection procedure. Procedures

5. Check the operation of the driver's seat position sensor with the HDS. Driver's Seat Position Sensor Operation Check





pro multis · About Operation CHARM