Yaw Rate Sensor: Testing and Inspection

SH-AWD Yaw Rate-Lateral/Longitudinal Acceleration Neutral Position Memorization

Whenever the yaw rate-lateral/longitudinal acceleration sensor is replaced, its neutral position be memorization must be done.

1. With the ignition switch in LOCK (0), connect the HDS to the DLC (A) located under the driver's side of the dashboard.

2. Turn the ignition switch to ON (II).

3. Make sure the HDS communicates with vehicle and the SH-AWD control unit. If it does not, go to the DLC circuit troubleshooting. Testing and Inspection

4. From the mode menu, select MISCELLANEOUS TEST, then select NEUTRAL MENU with the HDS and follow the screen prompts.
NOTE: See the HDS Help menu for specific instructions.