Dash Lights Brightness Controller Test/Replacement

Dash Lights Brightness Controller Test/Replacement

1. Remove the instrument fascia. Instrument Fascia Removal/Installation

2. Disconnect the 6P connector (A) from the dash lights brightness controller (B).

3. Remove the two screws and the dash lights brightness controller.

4. Check for continuity between terminals No. 5 and No. 6.
- There should be continuity when the ILLUMI (-) button is pressed.

- There should be no continuity when the ILLUMI (-) button is released.

5. Check for continuity between terminals No. 4 and No. 6.
- There should be continuity when the ILLUMI (+) button is pressed.

- There should be no continuity when the ILLUMI (+) button is released.

6. Check the LED by connecting battery power to terminal No. 1 and ground to terminal No. 2. The LED should come on.

7. If the continuity is not as specified, or the LED is faulty, replace the controller.