Navigation Cannot Control HVAC By Voice Command

Navigation System Symptom Troubleshooting - Navigation cannot control HVAC by voice command

Navigation cannot control HVAC with voice command

NOTE:

- Check the vehicle battery condition first Testing and Inspection.
- Check the connectors for poor connections or loose terminals.
- Check for and resolve all CAN DTCs before troubleshooting the navigation system.
- If the hard error code stored, check the hard error code troubleshooting first.
- Before troubleshooting, make sure you have the anti-theft codes for the audio system and the navigation system.
- After troubleshooting, enter the anti-theft codes for the audio system and the navigation system.
- Verify that the correct navigation unit is installed for this model. Go into the System Diagnostic Mode, and use Version.
- Make sure that the correct navigation DVD color and version are installed.
- Check any official Honda service website for more service information about the navigation system.

1. Connect the HDS to the DLC How to Troubleshoot the AcuraLink.

2. Check for B-CAN or F-CAN DTCs in the data list.

Are there any DTCs in the B-CAN or F-CAN systems?

YES -

Troubleshoot and repair all CAN related DTCs, and then retest.�

NO -

Go to step 3.

3. Turn the ignition switch to ON (II).

4. Check the hard error code.

Is there a hard error code stored?

YES -

Refer to the Hard Error Code troubleshooting.�

NO -

Go to step 5.

5. Substitute a known-good climate control unit Climate Control Unit Removal/Installation. Reconnect all connectors, and retest.

Does the symptom go away?

YES -

Replace the original climate control unit Climate Control Unit Removal/Installation.�

NO -

Replace the navigation unit Service and Repair.�