Traction Control Switch: Service and Repair

VSA Off Switch Test/Replacement

NOTE: If the low tire pressure indicator turns ON, the VSA cannot be turned OFF. Check the tire pressure first.

1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

2. Remove the driver's outer dashboard trim Driver's Outer Dashboard Trim Removal/Installation.

3. Remove the multi switch (with built-in VSA OFF switch) (A), then disconnect the multi switch 12P connector (B) and the power mirror switch 13P connector (C).






4. On the switch side, check for continuity between the multi switch 12P connector terminal in each switch position according to the table.






5. If the continuity is not as specified, remove the power mirror switch (A), then replace the multi switch (with built-in VSA OFF switch) (B).






6. Install the multi switch (with built-in VSA OFF switch) in the reverse order of removal.