Driver/Vehicle Information Display: Service and Repair

Multi-information Display Select/Reset/Information Switch Test/Replacement

1. Remove the steering wheel Steering Wheel Removal.

2. Remove the paddle shifter (+) (upshift switch) Paddle Shifter Replacement.

3. Disconnect the 12P connector (A) from the select/reset/information switch (B).





4. Remove the two screws (C), then pull out the center trim (D) from the steering wheel.

5. Remove the screw (E), then pull the select/reset/information switch from the steering wheel.

6. Measure the resistance between select/reset/information switch 12P connector terminals No. 1 [No. 4] and No. 11 in each switch position according to the table.
[ ]: Without ACC

With ACC





Without ACC









7. If the resistance is not as specified, replace the switch.

8. If the switch is OK, but there is a problem with the switch function, check the cable reel subharness and cable reel.