Ignition Switch Lock Cylinder: Service and Repair
Ignition Switch Lock CylinderREMOVING
1. Remove steering lock housing. Service and Repair
2. Remove ignition switch. Service and Repair
3. Drill steering column housing with 3 mm drill, according to illustration.
^ a = 9.0 mm (.35 in.)
^ b = 12.0 mm (.50 in.)
CAUTION: Do not drill too deep or lock cylinder will be damaged.
1. Insert ignition key into lock cylinder.
2. Push down retaining spring through hole with mandrel.
3. Remove lock cylinder.
INSTALLING
4. Insert key into lock cylinder.
5. Insert key with lock cylinder into housing in OFF position.