Scan Tool Functions, Selecting

After establishing diagnostic communication, checking the control module version and pressing --> button, proceed as follows:





Indicated on display
(Function selection, e.g. 02 - Check DTC Memory)
You can now select one of the functions listed below. Start the troubleshooting routine with function 02 "Check DTC Memory".
01 - Check Control Module Versions
02 - Check DTC Memory
03 - Output Diagnostic Test Mode
04 - Basic Setting
05 - Erase DTC memory
06 - End Output
07 - Code Control Module
08 - Read Measuring Value Block
09 - Read Individual Measuring Value
10 - Adaption
11 - Login procedure

The functions "Erase DTC memory" and "End Output" are described in the information.
The other functions listed here are described in the relevant parts of this information.
When a function has been performed and completed, press --> button in order to return to the start position of the troubleshooting routine: "Select function".

Erasing DTC memory
Requirements:
- DTC memory has been checked
- Press -4- button.





Indicated on display
- Press buttons -0- and -5- for the function "Erase DTC memory".





Indicated on display
- Press -Q- button to confirm input.





Indicated on display
- Press --> button.





Indicated on display





Notes:
^ If this appears in the display, the test sequence has not been performed correctly.
^ Keep exactly to the test sequence: First check DTC memory, then erase DTC memory in the same diagnostic cycle.

Ending Output





Indicated on display
- Press buttons -0- and -6- for the function "End Output".





Indicated on display
- Press -Q- button to confirm input.





Indicated on display
- Switch off ignition.
- Disconnect scan tool.