Overhaul Specifications

Torque converter






If the torque converter is correctly installed, the distance between the faces of the threaded hole at the torque converter and the contact face of the torque converter bell is about 23 mm (29/32 inch).
If the torque converter is not fully installed, this distance is about 11 mm (7/16 inch).

Valve body, oil pan and filter






Tighten the bolts for valve body -arrows- by hand at first.
Tighten bolts for valve body to final torque of 8 Nm (53 inch lb) in sequence from inside bolts to outside bolts.

Differential/Transmission housing






Tightening order:
- 1st stage: Tighten bolts - 1-, -2- and -3- by hand.
- 2nd stage: Tighten bolts -1- to -12- to final torque of 23 Nm (17 ft lb) in order shown.

Housing cover for front final drive





- Check that dowel sleeve -arrow A- is installed.

Tightening order:
- 1st stage: Tighten bolts -1-, -2- and -3- by hand.
- 2nd stage: Tighten bolts -1 - to -14- to final torque of 23 Nm (17 ft lb) in order shown.


Tightening torques