Basic Setting (Function 04)
Basic Setting
Basic setting must be performed after replacing a headlight, axle sensor or the control module. Observe the following:
- Vehicle must be in a precisely defined load condition.
NOTE: Current specified values and procedures for load condition can be found in the Repair Manual "Maintenance.
- Rock vehicle (move bumpers up and down several times, allowing vehicle to come to a rest on its own).
Perform basic setting
- Press buttons -0- and -4- to select "Basic Setting" function 04.
Indicated on display:
Rapid data transfer Q
04 - Basic Setting
- Press -Q- button to confirm input.
Indicated on display:
Basic Setting
Input display group number XXX
- Input display group number 001.
- Press -Q- button to confirm input.
Indicated on display:
System in Basic Setting 1 ->
Please wait
- Headlights are moved to set position.
Indicated on display:
System In Basic Setting 1 ->
Adjust headlights
- Headlights are now in the set position. Adjust headlights using headlight adjustment tool (e.g. VAS5046). Basic setting 1 switches the adjustment mode off and enters "headlights not set" into DTC memory.
- Press -> button.
Indicated on display
Rapid data transfer HELP
Select function XX
- Press buttons -0- and -4- to select "Basic Setting" function 04.
Indicated on display:
Rapid data transfer Q
04 - Basic Setting
- Press -Q- button to confirm input.
Indicated on display:
Basic Setting
Input display group number XXX
- Input display group number 2.
- Press -Q- button to confirm input.
Indicated on display:
System in Basic Setting 2 ->
Normal position learned
- The control module has now learned this position as the adjustment position. The entry in DTC memory ("Headlights not set") is erased and adjustment mode is re-initiated.
- Press -> button.
Indicated on display
Rapid data transfer HELP
Select function XX