Ignition Switch: Service and Repair

Ignition Switch, Removing And Installing

Removing


NOTE: It is not necessary to remove the lock cylinder.


- Disconnect battery Ground (GND) strap.
- Remove driver's-side airbag unit and steering wheel.
- Remove steering column switch.
- Disconnect harness connector from ignition/starter switch.







- Remove sealing paint from threads of screws -A-.
- Loosen two screws (arrows -A-) slightly and pull ignition/starter switch out of housing in direction indicated (arrow).

Installing


NOTE:
- The ignition switch and lock cylinder must be in the same position, e.g. "Ignition on" when installing.
- After installing, seal the screws again with pain.


- Install in reverse order of removal.

Ignition switch, terminal assignments







15 - Terminal 15
30 - Terminal 30
50 - Terminal 50
50b - Terminal 50b
75 - Terminal 75
86s - Terminal 86s
P - Park