With Manufacturer Scan Tool
Check DTC Memory (Scan Tool Function 02)
NOTE: The displayed DTC information is updated only when initiating OBD or with "Erase DTC Memory" function 05.
- Switch printer on via the PRINT button (indicator lamp in button lights up).
Indicated on display
Rapid data transfer HELP
Select function XX
- Press buttons -0- and -2-. This selects "Check DTC Memory", function 02.
Indicated on display
Rapid data transfer Q
02 - Check DTC Memory
- Confirm input using the -Q- button.
The number of stored DTCs are indicated on display.
X DTC recognized
The stored DTCs are displayed and printed out one after the other.
- Check printout against DTC table and repair all malfunctions as necessary, Navigation System III
If "No DTC recognized!" is displayed, the program will return to "Select function XX" after the -> button is pressed.
No DTC recognized ->
Indicated on display
Rapid data transfer HELP
Select function XX
If something else is displayed:
- End output (Function 06).
- Switch off ignition and disconnect diagnostic connector.