Fog/Driving Lamp: Service and Repair

Front fog lights, removing and installing


CAUTION! Disconnect the battery Ground (GND) strap before working on the electrical system

NOTE: Before disconnecting the battery, determine the correct coding for the anti-theft radio.
After reconnecting the battery, check and activate the vehicle's electrical equipment (radio, clock, comfort and convenience features, etc.).

- Remove bumper, refer to Body and Frame - Bumper - Service and Repair - Procedures Service and Repair

Removing






- Pry out plastic cover -2- and towing lug cover (right side) toward front.
- Remove two Torx (R) screws -1- (later Phillips-head screws).
- Remove headlight insert -3-.
- Disconnect harness connector.






- Remove Phillips-head screws -2- on housing cover.
- Release bulb retaining spring -1- and remove light socket from housing.






- Remove lamp connector -A- from cable connector in housing cover.

Installing

- Insert new bulb into light socket without touching glass with bare hands.
- Secure light socket with bulb retaining spring.
- Reconnect harness connector and close housing cover.
- Remainder of installation is in reverse order of removal.
- Adjust front fog lights after installing. Adjustments