Phase Position of Camshaft Position (CMP) Sensor

Check phase position of Camshaft Position (CMP) sensor

- Connect VAS5051 tester or VAG1551 scan tool and select the control module for engine electronics using "address word" 01. [1][2]Scan Tool Connecting and Initial Checks
Engine must run at idle for this.

When indicated on display:


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -8- to select "Read Measuring Value Block" and press -Q- button to confirm input.

When indicated on display:


Read Measuring Value Block Q
Input display group number XXX


- Press buttons -0-, -9- and -3- to select "display group number 093" and press -Q- button to confirm input.

When indicated on display:


Read Measuring Value Block 93 ->
1 2 3 4


- Check specified values of Camshaft Position (CMP) sensor

Display Group 93:

If specified values are obtained:
- Press -> button.

Indicated on display (function selection):

Rapid data transfer HELP
Select function XX