Engine Speed (RPM) Sensor -G28-, Checking

Engine Speed Sensor (RPM) -G28-, Checking

Special Tools and Equipment







- VAG1526A
- VAG1594A
- VAG1598/31

NOTE: The engine speed (RPM) sensor detects RPM and reference marks. The engine cannot be started without a signal from the engine speed (RPM) sensor -G28-. If the engine speed (RPM) sensor 428- signal fails while the engine is running, the engine will stop immediately.


Test sequence
- Before performing test, check sensor for proper installation and proper fitting.
- Disconnect harness connector for the engine speed (RPM) sensor (identification: gray harness connector).







- Connect multimeter between terminal 2 and 3 for resistance measurement.
- Specification: 730 to 1000 Ohms


NOTE: Resistance value of the engine speed (RPM) sensor is based on a temperature of 20°C. Resistance increases as temperature increases.


If specified value is not obtained:
- Replace engine speed (RPM) sensor.

If specified value is obtained:







- Connect multimeter to terminals 2 and 1 (shielding) and to terminals 3 and 1 (shielding ) for resistance measurement.
- Specification: each Infinity Ohms (no continuity )

If specified value is not obtained:
- Replace engine speed (RPM) sensor.

If specified value is obtained:
- Connect VAG1598/31 test box at wiring harness to ECM, do not connect ECM. Refer to "Scan Tool Testing/Scan Tool Connecting and Initial Checks/Connecting VAG1598/31 Test Box" Testing and Inspection







- Check the following wire connections for open circuit and short circuit to Ground (GND) and B+:







- Repair open circuit or short circuit if necessary.

If no malfunctions are found in wires:
- Replace Engine Control Module (ECM).