Left and Right-Rear Three-Point Seat Belts, Removing and Installing
Left And Right-rear Three-Point Seat Belts, Removing And Installing
Sedan
1 - Belt guide trim
- Large symbol must always point toward vehicle center
2 - Belt adjuster cover
3 - Retaining tab
4 - Belt adjuster
5 - Three-point seat belt
Removing:
- Remove rear seat.
- Remove bolt - 7 -.
- Unclip belt guide trim - 1 -.
- Detach belt adjuster cover - 2 - at left and right of retaining tab - 3 -.
- Remove rear shelf.
- Open cover for side trunk trim.
Vehicles with CD player and/or subwoofer or similar:
- Remove side trunk trim.
Vehicles with belt tensioners:
- Unclip igniter wire - 11 - at clip - 10 -.
- Detach harness connector for igniter wire at clip - 9 -.
- Remove bolt - 6 - (1x).
- Detach seat belt against direction of arrow.
Installing:
- Make sure harness connector for igniter wire - 11 - engages
- Clip igniter wire - 11 - into clip - 10 -.
NOTE: The igniter wire - 11 - must not be located near the belt webbing.
- For vehicles with belt tensioner, check belt-fastened sensor.
- After installing rear three-point seat belt, check belt function for child seat.
- Three-point seat belt must not be hindered by cables, wires or dampening material, etc
6 - Bolt
- 50 Nm (37 ft.lb)
7 - Bolt
- 50 Nm (37 ft.lb)
8 - Three-point seat belt with belt tensioner
9 - Clip
10 - Clip
11 - Igniter wire
Avant
1 - Bolt
- 50 Nm (37 ft.lb)
2 - Belt Tensioner
Removing:
- Remove left and right-rear side bolsters.
- Remove left and right-side trunk trim.
- Remove rear seat.
- Remove bolt - 4 - (1x).
Vehicles with belt tensioners:
- Unclip igniter wire - 11 - at clip - 10 -.
- Detach harness connector for igniter wire at clip - 8 -.
- Remove bolt - 1 - (1x).
- Detach seat belt against direction of arrow.
Installing:
- Make sure harness connector for igniter wire - 11 - engages.
- Clip igniter wire - 11 - into clip - 10 -.
NOTE: The igniter wire - 11 - must not be located near the belt webbing.
- For vehicles with belt tensioner, check belt-fastened sensor.
- After installing rear three-point seat belt, check belt function for child seat.
- The three-point seat belt must not be hindered by cables, wires or dampening material, etc
3 - Bracket
4 - Bolt
- 50 Nm (37 ft.lb)
5 - Bracket
6 - Bolt
- 2.5 Nm (22 in.lb)
- It is not necessary to remove metal bracket when removing belt
7 - Three-point seat belt with belt tensioner
8 - Clip
9 - Clip
10 - Igniter wire