Electrical/Electronic Components
5 Speed Automatic 01V
Electrical/Electronic Components And Locations
1 - Automatic Transmission Control Module (TCM) -J217-
- Control modules are checked via On Board Diagnostic (OBD).
2 - Engine Control Module (ECM)
- Control modules are checked via On Board Diagnostic (OBD)
3 - Data Link Connector (DLC)
4 - Conductor strip with Transmission Fluid Temperature (ATF) Sensor -G93-
- -G93- is checked via On Board Diagnostic (OBD)
5 - Valve body
- The solenoid valves - N88-, -N89-, -N90-, -N91-, -N92-, -N93- and -N94- are attached to the valve body
- Components are checked via OBD
6 - Multi-function Transmission Range (TR) switch -F125-
- Checked via On Board Diagnostic (OBD)
7 - Sensor for Transmission RPM - G182-
- Checked via OBD
8 - Transmission Vehicle Speed Sensor (VSS) -G38- (also referred to as Sensor for Transmission Output RPM -G195-)
- Checked via On Board Diagnostic (OBD)
- Records the transmission output speed
9 - Tiptronic switch -F189-
- The switch can be checked in, read measured value block and in the electrical check
10 - Shift lock solenoid - N110-
- Can be checked electrically and via reading measured value block
11 - Throttle Position (TP) sensor -G69-
- The TP sensor signal will be checked via On Board Diagnostic (OBD)
- The TP sensor signal is transmitted to the transmission control module via the engine control module. The signal can only be checked in measured value block. If OBD indicates a malfunction in the TP sensor, perform OBD for the Engine Control Module.
12 - Cruise control switch - E45-
- Location: The cruise control switch is on the steering column
- Can be checked during electrical test
13 - Starting interlock relay -J207-
14 - Transmission Range (TR) Selector Lever Display -Y6-
- When the TR Selector Lever Display does not light up, it indicates that the transmission is in emergency running mode with the Transmission Control Module (TCM) inactive.
- All segments of the IR Selector Lever Display light up, it indicates that the transmission is in emergency running mode with the TCM active.
15 - Kick down switch -F8-
- Can be checked electrically and via reading measured value block
16 - Brake Light Switch -F-
- Can be checked electrically and via reading measured value block.