With Manufacturer Scan Tool

Check DTC Memory (Function 02)

NOTE: The displayed malfunction information is not constantly up-dated but only when initiating the On Board Diagnostic (OBD) or with the function 05 "Erase DTC memory."

- Switch on printer with the Print button (indicator lamp in button lights up).

Performing function 02 - "Check DTC memory"

Indicated on display

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -2-.

Indicated on display

Rapid data transfer Q
02 - Check DTC memory

- Confirm input with -Q- button.

The number of DTCs stored will appear on the display.

X DTCs recognized! ->

The stored DTCs are displayed and printed out one after the other.

- Check printout against DTC table and repair all malfunctions as necessary.

If the message "No DTC recognized" is displayed the program can be returned to the starting point by pressing the -> button.

No DTC recognized! ->

Indicated on display

Rapid data transfer HELP
Select function XX

If something else is displayed:

- Erase DTC memory (function 05). With Manufacturer Scan Tool
- End output (function 06). End Output (Function 06)
- Switch off ignition and disconnect diagnostic equipment.