Rear Toe, Adjusting

Rear Toe, Adjusting

- Remove the nut - 1 - from the tie rod - 2 - to subframe connection.





- Adjust the toe by turning the eccentric bolt - 3 -.

Use the hole - arrow - in the subframe to turn the eccentric bolt.

- Install a new nut - 1 - and tighten it.

Specified values for wheel alignment. Refer to => [ Wheel Alignment Specifications ] Wheel Alignment Specifications.

• The maximum adjustment range is 90 degrees to the left or right of the center position.

• The geometric drive axle is automatically changed when individual toe settings are changed.

- After tightening the nut - 1 -, check the toe value again.