ESP Sensor Unit -G419-, Removing and Installing

ESP sensor unit -G419-, removing and installing
(ABS/ESP ITT Mark 60)

Removing
^ Remove storage compartment on driver's side.





^ Remove bolts (arrows).
^ Pull ESP sensor unit -1- in direction of travel and out of holder.
^ Unplug electrical connector-2-.

Note:
^ The ESP sensor unit is not resistant to shocks or impact.
^ Do not install an ESP sensor which has dropped to the ground otherwise proper operation is not ensured.

Installing
Install in reverse sequence; note the following points:
^ Initiate basic setting for the sensors in the ESP sensor unit.
^ Perform ESP road test.





Tightening torque