Diagnostic Trouble Code (DTC) Memory, Erasing

Diagnostic Trouble Code (DTC) memory, erasing, 01J CVT A/T FWD

Requirements
^ DTC memory read.
^ All DTCs corrected.

After DTC scan has been performed:





Display on VAS 5051
- Touch -1- diagnostic function "05 Erase DTC memory".





Display on VAS 5051:
1 - * No display (before erasing)
or
^ DTC memory erased

Note: If the message: DTC memory has not been read yet appears in display field -1-, the test procedure was not followed exactly. The DTC memory can only be erased if the DTC memory was read previously.

2 - Note: Are you sure you want to do this? Note: Data will be deleted!

- Touch "OK" button in display -2-.
- End function "05 Erase DTC memory" by touching [] button.
- After repair read DTC memory again.

Note: This erases DTCs which were stored during repair of the malfunction, for example by removing harness connectors.

- After reading and deleting DTC memory, test drive vehicle and read DTC memory again.
DTC memory must display:
"No DTC recognized"