Fuel Level Sensor 4, Checking, Right Tubular Sensor

Fuel Level Sensor 4, Checking, Right Tubular Sensor

Special tools, testers and auxiliary items required

• Hand-Held Multimeter (V.A.G 1526D)

• Connector Test Set (V.A.G 1594C)

Procedure

- Remove the ohms.

- Unbolt cover for right locking flange - arrows -.





- Disconnect electrical harness connector - 2 - at right locking flange.





• Ignore - 1 -.

- Connect multimeter between terminal - 2 - and - 3 - of connector - A - for resistance measurement.









• If measured value is 0 ohms there is a short circuit. If measured value is infinite ohms there is and open circuit in the wiring.

• To check resistance values "tank full" or "tank empty", the Fuel Level Sensor 4 (G393) must be removed. Refer to => [ Fuel Level Sensor 4, Right Tubular Sensor ] Fuel Level Sensor 4, Right Tubular Sensor and the sensor floater must be allowed to float to upper or lower end position.