Rear Bumper Cover Mounting Strip
Rear Bumper
Rear Bumper Cover Mounting strip
• Note direction of rotation for worm gear!
• Unlock the right slider by turning it to the right and the left slider by turning it to the left.
• After bumper cover has been loosened far enough at bolting points, release slider via the worm gear using an Allen wrench of 6 mm.
• Several rotations are necessary to do this.
• Doing this slides the retaining strip - 4 - downward and releases the retaining bolts - 5 - in longitudinal holes (keyhole profile) of cover.
• Cover can now be removed downward.
1 - Worm Gear
• Tighten to 1 Nm.
• Allen wrench 6 mm
CAUTION!
Caution! When installing, a tightening specification of 1 Nm must be observed.
Otherwise, worm gear of mounting strip will be damaged and it will be significantly more difficult to remove the bumper.
2 - Rear Body Wall
3 - Rear Bumper Cover
4 - Slider for Mounting Strip
• The slider is loosened by the worm gear on the right side by turning it to the right, or to the left on the left side.
5 - Retaining Bolts for Bumper Cover
• Retaining bolts are locked via slider, and unlocked during installation.