Mechanical Sun Shade
Rear Door Trim
Mechanical Sun Shade
Removing
- Remove door trim => [ Rear Door Trim ]. Rear Door Trim
- Remove bolts - 2 - (Qty. 5).
- Remove sun shade - 1 - from door - 3 -.
Installing
- Install sun shade - 1 - on door - 3 -.
- Tighten bolts - 2 - (Qty. 5) to the specified Tightening torque:.
- Make sure all the clips on the rear side of the door trim are clipped in.
- Replace damaged clips => [ Door trim securing clip ].
- Engage cable for interior door mechanism => [ Disengage release ].
- Connect harness connector on window regulator control module => [ Disconnecting harness connector at window regulator
control module ].
- Connect harness connector on bass speaker => [ Disconnecting harness connector on bass speaker ].
- Guide door trim - 2 - on to sun shade - 1 - and position door trim.
- Clip in door trim - 2 - to sun shade - 1 - (4 clips).
3 Clips
- Install door trim => [ Rear Door Trim ]. Rear Door Trim
Tightening torque:
Sun shade to door: 3 Nm