Coin Tray
Coin Tray
Removing
- Open coin tray.
- Slide coin tray panel toward the left out of catch - arrow - and remove.
- Open glove compartment.
- Carefully disengage decorative panel - 1 - with switch strip - starting above the glove compartment - from instrument panel using trim removal wedge (3409).
- Pull off decorative panel with switch strip in - direction of arrow -.
• Be especially careful when releasing clip on the driver's side end of decorative panel.
- Disconnect electrical connector.
- Turn knurled wheel - 3 - for left air vent above glove compartment completely upward.
- Insert one watchmaker's screwdriver each - 1 - into air vent retaining clamps above the lower ventilation fin - 2 -.
- Pull air vent alternating on left and right side out of the installation opening, watchmaker's screwdrivers must remain inserted while doing this.
• Pull air vent out of installation opening using Hook (3438) if necessary.
- Disconnect electrical harness connector at air vent.
- Release retaining tabs - 1 - of coin tray.
- Pull coin tray out of instrument panel - arrow -.
- Disconnect the rear electrical harness connector on coin tray.
Installing
Installation is reverse of removal, noting the following:
- When inserting decorative panel - 1 - with switch strip, make sure that both catches in panel center are inserted between instrument panel and screen housing - arrows -.