Telescoping Wheel Switch: Service and Repair
Steering Column Adjustment Switch E167, Removing And Installing
Special tools, testers and auxiliary items required
- Special screwdriver T8 T40056 A
Removing
CAUTION: Follow safety precautions when working on knee airbag.
- Remove drivers storage compartment.
- Lower steering wheel as far as possible to rear, making use of the full range of the steering column adjuster.
- Remove bolts - 3 - and - 4 - using screwdriver T8 T40056 A.
- Remove Torx bolt - 5 -.
- Separate upper trim - 2 - for steering column switch from lower trim - 1 - and detach both sections.
- Disconnect electrical harness connector at lower trim.
NOTE: Steering wheel has been removed in illustration.
- Remove screws - arrows -.
- Lift Steering Column Adjustment Switch E167 - item 1 - out of lower trim.
Installing
Install in reverse order of removal, observing the following:
- Install drivers storage compartment.
Tightening torques
Steering Column Adjustment Switch E167 to lower trim: 2.5 Nm
Trim for steering column switch: 1 Nm
Lower trim to steering column: 2.5 Nm