Plenum Chamber E-Box Connection Point

Relay and Fuse Panels

CAUTION!
Before beginning repairs on the electrical system:

• Obtain the anti-theft radio security code.

• Switch the ignition off.

• Disconnect the battery Ground (GND) strap.

• After reconnecting vehicle battery, re-code and check operation of anti-theft radio. Also check operation of clock and power windows according to Repair Information and/or Owner's Manual.

• Steps after reconnecting voltage supply => Battery.

Plenum Chamber E-Box Connection Point

Removing

• All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.

- Remove driver's storage compartment.

- Unbolt the electrical cable at bottom of connection point, E-Box in plenum chamber.

- Remove rubber seal for plenum chamber cover.

- Remove plenum chamber cover - 1 - toward front - arrows -.





- Use a screwdriver to pry off the two caps - 3 -.





- Loosen hex nuts - 4 - by several turns.

- Loosen wiper arm - 2 - from wiper axle by lightly tilting.

- Remove hex nuts completely and remove wiper arms.

- Disconnect securing clips - 1 - and remove cowl panel grill - 5 -.

- Remove cover for E-box, plenum chamber - arrows -.





- Using a screwdriver, pry off retaining bar - arrow -.





- Set aside Engine Control Module (ECM) with cables connected.

- Unclip Transmission Control Module (TCM) retaining bracket.

- Set aside Transmission Control Module (TCM) with cables still connected.

- If present, cut through cable ties.

- Disconnect connectors at rear of connector rail.

- Unscrew wire connection - 2 -.





- Remove bolts - 1 - and - 3 -.

- Unclip the corresponding connector base.

• Check the exact assignment for connection point E-Box plenum chamber in the current wiring diagram.





•

Installing

Installation is reverse of removal, paying attention to the following:

• All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.

Tightening Specifications