Seat Pan Assembly Overview

Power Front Memory Seats, from November 2004

• From August 2005, the conventional wiring harness routing to the connector station under the front seat, refer to => [ Connectors, Disconnecting ] has been replaced with modular wiring routing => [ Modular Wiring Routing Assembly Overview, from August 2005 ].

• The modular wiring routing has not been implemented for all countries.

Seat Pan Assembly Overview

• On the front seat, the upper and lower seat pan frames can be separated and replaced individually.

• When removing seat pan, ensure bushings in bearing points (upper and lower frame threaded connection) are not damaged. These bushings cannot be replaced with workshop materials.





1 Screw

Self-locking

• 28 Nm

• Quantity: 3

• Replace

• Threaded holes for screws must always be cleaned (for example, with thread cutter)

2 Seat Pan Upper Frame

• Removing and Installing, refer to => [ Seat Pan, Disassembling and Assembling ] Seat Pan, Disassembling and Assembling

3 Bushing

• inserted in all bracket locations

• cannot be replaced with workshop materials

• if bushings are damaged, assembly part must be replaced.

4 Seat Pan Lower Frame

• Removing and Installing, refer to => [ Seat Pan, Disassembling and Assembling ] Seat Pan, Disassembling and Assembling

5 Bolt

• 28 Nm

• Replace

6 Nut

• Threaded holes for screws must always be cleaned (for example, with thread cutter)

7 Driver's Seat Height Adjustment Motor (V245) or Front Passenger's Seat Height Adjustment Motor ( V246)

• Removing and Installing, refer to => [ Seat Height Adjustment Motor ] Power Front Memory Seats, From November 2004

8 Seat forward/Back Adjustment Motor (V288)

• Cannot be removed and installed with workshop materials

• Stays on seat pan lower frame, refer to - 4 -

9 Driver seat angle adjustment motor (V243) or Front Passenger Seat Angle Adjustment Motor (V244 )

• Removing and Installing, refer to => [ Seat Angle Adjustment Motor ] Power Front Memory Seats, From November 2004

10 Screw, self-locking

• 20 Nm

• Replace

• Threaded holes for screws must always be cleaned (for example, with thread cutter)