Holding Frame

Front Seats

• From 06.2006, the usual wiring harness routing to connector station under front seat. Refer to => [ Connectors, Disconnecting ] Front Seats has been replaced with modular wiring routing => [ Modular Wiring Routing Assembly Overview, from June 2006 ] Front Seats.

• The modular wiring routing has not been implemented for all countries.

• Check version of front seat and of vehicle and perform repairs accordingly.

• Note the two possible versions of the modular wiring routing, Modular Light or Modular. Refer to => [ Modular Wiring Routing Versions ] Front Seats.

Holding Frame





1 - Front Seat

2 - Clips (Qty. 2)

3 - Holding Frame

• Removing

- Remove backrest cover panel. Refer to => [ Backrest Cover ] Backrest Cover.

- Pry out the left and right circlips - 8 - (Qty. 4).

- Open the left and right Velcro fasteners - 7 - (Qty. 4).

- Disengage the side molding - 9 - (Qty. 2).

- Remove the lower molding - 6 - (quantity: 3).

- Pry out clips - 4 - (Qty. 3).

- Remove the clips - 2 - (Qty. 2).

- Disengage the holding frame - 3 - from the backrest frame.

• Installing

- Engage the holding frame - 3 - on brackets - 5 - (Qty. 2) in backrest frame.

- Continue to install the holding frame - 3 - in reverse order of removal.

4 - Clips (Qty. 3)

5 - Retainers (Qty. 2)

6 - Lower Molding (quantity: 3)

7 - Velcro Fasteners (Qty. 4)

8 - Clamps (Qty. 4)

• Commercially available according to the manufacturer instructions.

• Use only cushion clips.

9 - Side Molding (Qty. 2)