Impact Sensor: Service and Repair
Airbag Crash Sensors, Servicing
=> [ Front Airbag Crash Sensor ]
=> [ Front Side Airbag Crash Sensor ]
Front Airbag Crash Sensor
CAUTION!
Observe safety precautions for work on airbags
1 - Front Airbag Crash Sensor
• Removing
- Disconnect the battery ground strap.
- Depending on engine version, remove air duct if necessary.
- Disengage tab on yellow connector - 3 - and disconnect connector.
- Remove two bolts - 2 - on crash sensor - 1 -.
• Installing
- Switch on ignition.
CAUTION!
No one should be in vehicle when connecting battery.
- Connect battery ground strap.
2 - Screws, (Qty. 2)
• Tightening specification 9 Nm.
3 - Connector
4 - Lock Carrier
• Follow the safety precautions after connecting the battery.
• If the Airbag Malfunction Indicator Lamp (MIL) ( K75) shows a malfunction after assembly, DTC memory must be checked with Vehicle Diagnostic, Testing and Information System ( VAS 5051 A), cleared and then rechecked.
Front Side Airbag Crash Sensor
CAUTION!
Observe safety precautions for work on airbags
• Removing
- Disconnect the battery ground strap.
- Remove side trim. Refer to => [ Left Side Trim ] Luggage Compartment Trim.
- Remove bolts - 2 - (Qty. 2).
• Tightening specification 9 Nm.
- Disconnect the connector on the crash sensor - 1 - and remove it - 1 -.
• Installing
- Install crash sensor - 1 - in reverse order of removal.
- Switch on ignition.
CAUTION!
No one should be in vehicle when connecting battery.
- Connect battery ground strap.
• Follow the safety precautions after connecting the battery.
• If the Airbag Malfunction Indicator Lamp (MIL) ( K75) shows a malfunction after assembly, DTC memory must be checked with Vehicle Diagnostic, Testing and Information System ( VAS 5051 A), cleared and then rechecked.