Exterior Rearview Mirror Unit

Exterior Rearview Mirror Unit

Special tools, testers and auxiliary items required

• Lever (80-200)

Assembly overview





1 - Mirror housing

• May be removed from door without removing entire rearview mirror => [ Exterior Rearview Mirror Housing ] Exterior Rearview Mirror Housing.

2 - Adjusting motor

• Removal => [ Exterior Rearview Mirror Adjusting Motor ] Service and Repair

3 - Mirror adjusting unit

• Before replacing, window frame must be removed => [ Window Frame and Regulator ] Window Frame and Regulator.

• Before removing, remove rearview mirror from door

• To remove, pry off mirror lens, disconnect electrical harness connectors for mirror heater, remove phillips-head screws - 6 - and remove mirror adjusting unit from mirror housing - 1 -.

4 - Mirror lens

• Use special tool Lever (80-200) to unclip.

• Protect mirror housing against damage using textile tape above and below.

• Press mirror lens first downward, then upward.

• To install mirror lens into guide pins and friction finger, insert into friction spring and press on.

• Apply pressure only on center of glass, wear protective gloves while doing so.

5 - Front door

6 - Electrical harness connector

7 - Combination bolt

• 12 Nm

8 - Gasket

• Ensure correct seating when installing.

9 - Mirror base