Four-Way Lumbar Support Motors, From MY 2006
Four-Way Lumbar Support Motors, from MY 2006
1 Backrest Padding
2 Lumbar Support
3 Clamping Sleeve
4 Lumbar Support Frame
5 Actuator For Lumbar Adjustment
• Removing
• When replacing actuator, lumbar support must not be at an end position.
- Remove backrest cover panel. Refer to => [ Backrest Cover ].
- Disconnect electrical harness connector. Refer to => [ Disconnecting electrical harness connector and disengaging retaining bracket at actuator ].
- Disengage retaining bracket and remove actuator downward.
• Installing
Installation is performed in reverse order of removal, noting the following:
- Actuator can only be installed in one position.
6 Central Screws
For centering lumbar support to lumbar support frame
7 Rivet
8 Plastic Washer
9 Actuator for Lumbar Height Adjustment
• Removing
• When replacing actuator, lumbar support must not be at an end position.
- Remove backrest cover panel. Refer to => [ Backrest Cover ] Backrest Cover.
- Disconnect electrical harness connector.
- Disengage retaining bracket and remove actuator upward.
• Installing
Installation is performed in reverse order of removal, noting the following:
- Actuator can only be installed in one position.
10 Fastening Strips
Disconnecting electrical harness connector and disengaging retaining bracket at actuator
• When replacing actuator, lumbar support must not be at an end position.
- Disconnect electrical connector - 4 -.
- Disengage retaining bracket - 3 - using a screwdriver - 2 - and remove actuator - 1 -.