Trim, Tunnel Side

Trim, Tunnel Side

Removing

CAUTION!
• Observe safety precautions for work on airbags.

• Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "discharge static electricity". This can be done by touching door striker, for example.

- Remove front seat. Refer to => [ Seat ] Seat.

- Attach seat to Fixture For Seat Repair (VAS 6136 ).

- Disengage cover at seat pan upper frame.

- Disengage grip channel - 1 - on footwell cover - 2 - from brackets - 4 - (Qty. 2) on tunnel side trim - 3 -.





- Remove expanding rivets - 2 - (Qty. 2).





- Remove tunnel side trim panel - 1 - upward.

Installing

To install, perform the steps used in removal in reverse order. Observe the following when doing so:

CAUTION!
• Observe safety precautions for work on airbags.

• Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "discharge static electricity". This can be done by touching door striker, for example.

• Ensure that electrical connections are pushed in as far as stop and engage with a click.

- Switch on ignition.

CAUTION!
Ignition must be on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

- Connect battery ground wire with ignition switched on.

- If Airbag Malfunction Indicator Lamp (MIL) (K75 ) indicates a fault after installation, DTC memory must be checked, deleted and checked again. Refer to => Vehicle Diagnosis, Testing and Information System (VAS 5051B).